![]() Here I will share the method I tried for STM32 Nucleo-L4R5ZI board. How to Enable Bootloader in STM32 Nucleo board ? Additionally, You may same some power as well by using UART interface. ![]() STM32 devices have inbuilt bootloader which can be activated based on certain hardware & software configuration. Similarly we need some bootloader in embedded system as well which can be used to update system software in the field. No, Think about the situation when your hard-disk crashes, BootROM plays an important role in that case. That will fulfill the basic application programming requirement. One can find equipment to do mass programming of STM32 devices. The reason is obviously to reduce BoM (Bill Of Material) cost. But no one will prefer to integrate such debugger interface in final product. This part itself one small embedded product with MCU, USB interface and other components. The ST-LINK part was discussed during STM32 Nucleo-L4R5ZI board introduction. So far we have used ST-LINK in all the STM32 related material. Explanation of programming options, Bootloader & DFU driver installation in Wiindows 10 with Nucleo-L4R5ZI board. In this article, We will discuss Installation of STM32cube programmer.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |